Hi everyone. I am doing some updating on my unground pool, 16x34, 8 foot deep in deep end. I am adding a new pentair 1.75 HP variable speed pump, Hayward salt cell and possibly a Hayward omnihub. Right now my pools electrical is a 20 amp double pole breaker with what I assume to be 12 gauge wire, there are two hots and neutral and a ground. My current pool equipment that runs off this electric is a hayward 1hp super pump, a receptacle and my pool light. There was a gas heater on this same breaker but it is no longer functional.
Would my current electrical setup be able to power my new equipment including my pool light and outlet or should I do some upgrading there as well? I can always fish some extra wires through the conduit that goes back into my basement.
What is standard electrical for a new pool setup these days?
I’m in NJ by the way.
Would my current electrical setup be able to power my new equipment including my pool light and outlet or should I do some upgrading there as well? I can always fish some extra wires through the conduit that goes back into my basement.
What is standard electrical for a new pool setup these days?
I’m in NJ by the way.