I just installed/upgraded to iAqualink3 and replaced my dead pump with a VSPF. I flipped the 3rd dipswitch on the Jandy board to enable spillover. The issue now is that my air blower now also turns on when the spillover is on. Any ideas on how I can correct this behavior?
Spillover Issue
- Thread starter JDunks
- Start date
- May 3, 2014
- 58,523
- Pool Size
- 6000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
From the Aqualink Wiki
If you have any relay connected to AUX3 you need to move it to an available Aux position.
If you have any relay connected to AUX3 you need to move it to an available Aux position.
Aux 3 is vacant as per the instructions whne flipping the 3rd dipswitch to on. Thanks
- May 3, 2014
- 58,523
- Pool Size
- 6000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
Forgot to post. I turned the rpm's down on Spillover mode and that corrected the problem.
Similar threads
