What’s up TFP,
I control my pool and spa using easy touch and ScreenLogic 2. When I turn my spa on one jet has water coming out but with little pressure. I have my spa set at 100 gpm. But when I look at my screen logic it only registers 55 gpm. When I turn on the blower for a minute and shut it off all the jets are working. I check the rpm again and now it’s reading 100 gpm. Which is what I have it set at. To sum up this mess. My spa does not work unless I turn the blower on first. Very strange. Any ideas?
I control my pool and spa using easy touch and ScreenLogic 2. When I turn my spa on one jet has water coming out but with little pressure. I have my spa set at 100 gpm. But when I look at my screen logic it only registers 55 gpm. When I turn on the blower for a minute and shut it off all the jets are working. I check the rpm again and now it’s reading 100 gpm. Which is what I have it set at. To sum up this mess. My spa does not work unless I turn the blower on first. Very strange. Any ideas?
Attachments
Last edited by a moderator: