- Feb 16, 2021
- 48
- Pool Size
- 13400
- Surface
- Vinyl
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
My automation panel is still on order, so my electrician temporarily brought main power from my panel, to a disconnect box ( similar to what you'd have for an air conditioner ) Anyway both my intelliflo vsf and raypak 266k heater is powered from that box.
again this is supposed to be temporary until I get my panel.
The heater is throwing Water sw open errors because when the pump stops.. there is nothing except the heaters flow switch to stop the heater.
Should I just run my pump 24/7 at 41 gpm flow so there is always enough flow for heater..
How do people usually do this?
I am trying to run a schedule ( basically run for 8 hours.. off for 5. run 7..off for 4.
If you try to use the internal scheduling of the pump.. how do you control the heater to be in sync..
Or can I just rely on the flow sensor switch in the heater ... that seems wrong to me...
again this is supposed to be temporary until I get my panel.
The heater is throwing Water sw open errors because when the pump stops.. there is nothing except the heaters flow switch to stop the heater.
Should I just run my pump 24/7 at 41 gpm flow so there is always enough flow for heater..
How do people usually do this?
I am trying to run a schedule ( basically run for 8 hours.. off for 5. run 7..off for 4.
If you try to use the internal scheduling of the pump.. how do you control the heater to be in sync..
Or can I just rely on the flow sensor switch in the heater ... that seems wrong to me...