Putting up a pool from pool factory. Made by Yardmore. Found a couple measurement typos, like impossible measurements. That wasn’t the worst of it though. Today we went to set the opposite side legs and they provided the diagonal measurements in the diagram. The CAD drawing appears to be in the center of the track on the leg. A picture in a different section shows measuring from the edge of the leg itself. Video on YouTube shows measuring from the flange on the diagonal support. None of those are correct. It’s from the self tapping screw holding the track piece on. After resetting the outside legs 3x I gave up and re-Mathed it out and got it done using a more convenient spot on the legs but lost most of the day.
Public service announcement, instructions suck!!!
- Thread starter nwardoh
- Start date
Good job figuring it out BUT you should not have to work that hard on something like that!
I've installed two of their pools and the instructions are terrible .
I've mentioned it on here before.
I'd still buy another and I even had my boss buy one but the instructions...... Oh boy.
That and we had to modify some parts to work as they were made wrong.
Mine has..I think we're on it's 3rd year.
My bosses did also... Until Ida.
It didn't tolerate the water around it being several feet deeper than it was.
