Yeah. I'd make a bleach mix in a bucket to dip the brush in like a mop, then scrub upside down.Do I just try to hit it with the brush ?
Yeah. I'd make a bleach mix in a bucket to dip the brush in like a mop, then scrub upside down.Do I just try to hit it with the brush ?
No loss minus the daily UV loss. It sound like you're about there and should move on to OCLTs. Last night went up a bit so it's screwy and I wouldn't trust it. Give it a go tonight if all traced of the gunk is gone.Am I looking to hold 24 for x hours with no loss?
What is Langelier saturation index ?
I received an email about my fiberglass care says chlorine over 5 ppm for superchlorination etc needs to have LSI 0 . Or can cause damage to pool surface
Is this relevant
It’s similar to the CSI in pool math. But. It related to any chlorine levels.
You may never hit 24 if the chlorine starts degrading right after you add it. I’m going to assume you added some after the 22.5 measurement?Water is crystal clear
Cc has stayed very consistent at 0.5
Been adding Lc every 2 hours all day (usually 6 am to 8pm) accordingly
Last night 8:30 fc 22.5
Today 9 am fc 23
Will there come a time that I hit my slam target and hold it for a period of time ? Am I looking to hold 24 for x hours with no loss?
Yes I add every time because it’s never 24I’m going to assume you added some after the 22.5 measurement?
Got it . Im fine with a few more days of this if it seals the deal. I mean I’d hate to come this far to have to start over.You want 1 or less loss FC and .5 or less CC.
It would start degrading because there is still gunk somewhere I can’t see ?You may never hit 24 if the chlorine starts degrading right after you add it
During the SLAM, yes. At the end you should reach target if the bleach is fresh.It would start degrading because there is still gunk somewhere I can’t see ?