- Aug 5, 2013
- 219
- Pool Size
- 12000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
Have the Pentair 522104 Screenlogic2 Interface & Wireless Connection Kit that reads "Connecting to Pool Controller Please Wait" when trying to connect on PC. On phone it connects, but the statuses are all incorrect.
Protocol Adapter has Red light on it
Indoor Wireless Transciever has PWR rapidly flashing (~3 flash/sec), TX and RX are not flashing
Outdoor Wireless Transciever has PWR slowly flashing (~1 flash/sec), TX never flashes (dont even see a RX LED)
Tried power cycling the Protocol Adapter and the Indoor Transceiver to no effect.
I cannot hard wire the units together to test. Is there any way to definitely test?
Protocol Adapter has Red light on it
Indoor Wireless Transciever has PWR rapidly flashing (~3 flash/sec), TX and RX are not flashing
Outdoor Wireless Transciever has PWR slowly flashing (~1 flash/sec), TX never flashes (dont even see a RX LED)
Tried power cycling the Protocol Adapter and the Indoor Transceiver to no effect.
I cannot hard wire the units together to test. Is there any way to definitely test?