On Thursday we had our main circuit panel rebuilt and upgraded from 150 to 200 amp to be up to code. 24 hours after they left we realized the pump is no longer working and showing Err 000F. I've read through the other posts with this error code but have a more specific question. Is it possible this upgrade burned something on the pump? The electrician won't come back until Tuesday (Labor Day Weekend) and is saying this isn't his fault and he can't fix it. Is that right? Is this now a pump problem not a voltage problem? The owners manual says that this indicates the voltage has dropped below operating range or a voltage sag. Can the electrician fix this?
I've flipped the breaker, waited five minutes, flipped it back on multiple times. The pump will try to run at a low rpm (1,000 or lower) for a few minutes and the shuts off. Anything higher and it shuts off after 10 seconds. Done a factory reset.
Thanks for any help you pool / electrician experts can provide! (and send good vibes for a clear pool until we figure this out!)
I've flipped the breaker, waited five minutes, flipped it back on multiple times. The pump will try to run at a low rpm (1,000 or lower) for a few minutes and the shuts off. Anything higher and it shuts off after 10 seconds. Done a factory reset.
Thanks for any help you pool / electrician experts can provide! (and send good vibes for a clear pool until we figure this out!)