Omnilogic can’t calibrate screen Help

[Fixerupper55]

I believe I tried everything but figured I’d try and ask on here. Unable to recalibrate screen. Get to the final screen to click the check mark in bottom right, but touchscreen is so far off it won’t let me hit it. Bought this unit used and has really old firmware. I tried holding on the screen during boot up but old software doesn’t respond to this option. Bought a new lcd screen because I read that might fix but didn’t. Is there anyway to force firmware upgrade so I can recalibrate screen? Thanks!!

 

[ajw22]

Welcome to TFP.

See if your old firmware has the SHELL command...

Hayward Omnilogic touch screen problem

I have a Hayward Omnilogic. Is there any way to calibrate the touch screen on it? When I touch a specific spot, it thinks I am touching about 1/2 inch lower. Makes it almost impossible to touch anything in the top row. Every so often I get lucky. :D Disappointing from a unit that is 2...

www.troublefreepool.com

Hayward OmniLogic - Further Reading

www.troublefreepool.com

 

[Fixerupper55]

Yes it does

 

[Fixerupper55]

I just can’t hit the check mark to recalibrate.

 

[ajw22]

Then you may be stuck and need to replace the board.