Brand new PCB aqua Logic Pro board installed. First thing I get a “no cell power” error. Cleaned cell, checked all wiring and then removed the board. Looks like either the R64 or U7 circuit is burned.
No cell power error shows up on new PCB
- Thread starter westhart
- Start date
- Jul 21, 2013
- 65,137
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
You can clearly see the solder points that have been burned. Problem is if I solder them I can’t return the board. Is this a bad board or do I have other problems? Also it is notable that the pool water is clear which makes me thing that the cell is good but some communication error is present.
The old board was replaced because it didn’t communicate with the remote. I tried to fix it and probably made it worse. Point being, the old board did not show “no cell power”
Thanks
The old board was replaced because it didn’t communicate with the remote. I tried to fix it and probably made it worse. Point being, the old board did not show “no cell power”
Thanks
Attachments
Looks like a used/damaged generic Chinese board, not a new OEM Board.
Last edited:
Detailed Seller Information
Business Name: guangzhouhanfenshangmaoyouxiangongsi
Business Address:
黄家坝街道办事处大寨村星光组184号
遵义市
湄潭县
贵州省
564104
CN
No. 184, Xingguang Group, Dazhai Village, Huangjiaba Subdistrict Office
Zunyi City
Meitan County
Guizhou Province
Business Name: guangzhouhanfenshangmaoyouxiangongsi
Business Address:
黄家坝街道办事处大寨村星光组184号
遵义市
湄潭县
贵州省
564104
CN
No. 184, Xingguang Group, Dazhai Village, Huangjiaba Subdistrict Office
Zunyi City
Meitan County
Guizhou Province
Hebei Xingguang Group Co.,Ltd.
Key Principal: Cunxing Wang.
Key Principal: Cunxing Wang.
Oh, wow. I bought it through Amazon so I can return it. Good to know. Think Amazon would want to know ?
Similar threads
