- Sep 19, 2010
- 12
- Pool Size
- 26000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
I replaced the membrane pad went from a 9 pin to a 6. I correctly placed it on pins 4-9. After that the heater won't start. It comes up all 888 then gives a 180/R9 error and lights up Service Heater and SFS. I purchased and installed a new Stack Flue Sensor and it ohms out to 3.5 m Ohms per specs.
Prior to the membrane replacement it would start.
Any ideas, thank you.
Prior to the membrane replacement it would start.
Any ideas, thank you.