Magnum Force Wet end removal

mas985

LifeTime Supporter
TFP Expert
May 3, 2007
12,109
1
Pleasanton, CA
sites.google.com
#2
I am not sure what you have done so far but here is a drawing that might help.

Remove ring 21 and the whole motor with impeller should slide out.

You can then remove the screws that hold the motor to motor plate.

 

Citizen

In The Industry
Oct 2, 2014
92
0
Orlando, FL
#3
I am trying to separate a motor from the pump housing to replace the motor. I can not get the a part. I have removed the coupler ring and there seem to be no screws holding them together.

Any ideas?
Once you remove number 21, the locking ring, the motor and drive assembly should come out. Mind you it is probably a little stubborn because it has been installed for awhile. I would bleed the pressure in yours system to make it a little easier and then use a flathead screwdriver to pry it open. Don't go crazy with the screwdriver though, you may break the pump.