PB4-60Q
Replaced parts over the years. A few o-ring seals..a volute...a ceramic seal.
BUT... just found a crack in the 'back' of the volute area... Not the front, which is clamped on...this is on the back side that appears to be part of the motor. On the diagram it is #1. (Crack is around 1.5" long, circumferentially just next to the clamping ring. (As you look at the ring in place, about 1/8" from the ring)
The old parts diagram calls this "P64". You buy the motor WITH this part.
That is, if it were still made. Looks ike I am buying a new pump.
Agree?
Replaced parts over the years. A few o-ring seals..a volute...a ceramic seal.
BUT... just found a crack in the 'back' of the volute area... Not the front, which is clamped on...this is on the back side that appears to be part of the motor. On the diagram it is #1. (Crack is around 1.5" long, circumferentially just next to the clamping ring. (As you look at the ring in place, about 1/8" from the ring)

The old parts diagram calls this "P64". You buy the motor WITH this part.
That is, if it were still made. Looks ike I am buying a new pump.
Agree?