So, I added a Jandy Trudose Controller to my setup, and ever since then, I have been unable to chlorinate my pool adequately. Although I can get the pH in check through the system, the SWG control has been disastrous. After reading many posts here, I purchased a replacement sensor kit (my salt cell is approximately 3 years old, and I winterize it) as I was getting a no-flow message from the old one. The new one shows flow, so I thought I would be all good, but after running the boost pool for 24 hours, my chlorine levels have dropped even further. Is my cell dead? Is the controller junk? Any help would be truly appreciated.