Jandy truclear keeps on resetting to 100% at start
- Thread starter nikki238
- Start date
- Jul 21, 2013
- 65,369
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
- Jul 21, 2013
- 65,369
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Maybe a bad circuit board.
Maybe try removing the battery and disconnecting the RS-485 blue connector to see if that makes any difference.
Maybe try removing the battery and disconnecting the RS-485 blue connector to see if that makes any difference.
- Jul 21, 2013
- 65,369
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Nothing right now, just trying random things before replacing the circuit board.
Maybe call Jandy to see what they can tell you.
How old is the system?
The blue terminal block connects to the white terminal block by the grey wire and nothing is connected to the white terminal block.
Just disconnecting it in case maybe the wires are shorted etc.
It probably won't make any difference.
Just disconnecting it in case maybe the wires are shorted etc.
It probably won't make any difference.
i called jandy but it was pretty much a waste of time the system was installed 2/21
I do not know what else to try.
Have you contacted the installer to see if they can help you?
Have you contacted the installer to see if they can help you?
TFP is a registered 501(c)3 non-profit that is maintained by user donations.
All of our content is free of advertisements.
Please consider donating at:
www.troublefreepool.com
All of our content is free of advertisements.
Please consider donating at:
Become a TFP Supporter
Help Support TFP Trouble Free Pool is run by a dedicated group of volunteers that … Read more…
www.troublefreepool.com