I started receiving a 125/194 Error Code from my chlorine generator last week. I spent a bit of time researching and learned how to clean it. There was a bit of buildup inside so I first tried to clean it with a hose. This didn't work so I used a water muriatic acid combo which did the trick. I hooked everything back up and it seemed like things were fine, but then I started getting a 123 error code. I did some more research and decided to clean the leads on the chord although they did not appear to have any buildup. Once again, I hooked everything back up and thought things were fine but the 123 error code happened after about 10 minutes. The code has been intermittent since that time. Should I just wait this out a bit longer? Test strips look like I am starting to see some FC.
My salt is 4500 PPM.
This is the third season for my pool and this is the first time I've cleaned the SWG. I honestly did not know this was something that needed to be done.
Any advice would be greatly appreciated. I have a graduation party this weekend and would like to resolve this myself. After reading the forums it sounds like this could be a bad board, but I figured I'd ask here first.
Thanks,
John
My salt is 4500 PPM.
This is the third season for my pool and this is the first time I've cleaned the SWG. I honestly did not know this was something that needed to be done.
Any advice would be greatly appreciated. I have a graduation party this weekend and would like to resolve this myself. After reading the forums it sounds like this could be a bad board, but I figured I'd ask here first.
Thanks,
John