Intex Intake Measurement

[CT-Steven]

We are upgrading our 9x18 to a 12x24 and I was hoping I could utilize my existing 1.5" PVC hard piping. Can someone please measure center to center on their 12x24 intakes. Would be appreciated

 

[ajw22]

Did you get your measurements?

 

[kellyfair]

We are upgrading our 9x18 to a 12x24 and I was hoping I could utilize my existing 1.5" PVC hard piping. Can someone please measure center to center on their 12x24 intakes. Would be appreciated

I don’t have an Intex anymore, otherwise I would do for you! Is the concern that the intakes might be too small? They are easy to cut, if so.

Doubt they would be larger than 1.5”!

 

[CT-Steven]

My 9x18 is all 1.5" I would like to re-use my existing piping with knowing some of it might need to be extended. As a visual person I was hoping that I did not have to alter the existing intake piping that I built thus hoping that the distance between them remained the same? And nope no replies or messages

 

[Mdragger88]

Get you some couplings & a little xtra piece of pvc & be prepared to do a little surgery. It’s unlikely that the distance will be exactly the same.

 

[kellyfair]

My 9x18 is all 1.5" I would like to re-use my existing piping with knowing some of it might need to be extended. As a visual person I was hoping that I did not have to alter the existing intake piping that I built thus hoping that the distance between them remained the same? And nope no replies or messages

Ah, apologies, I misread. Best to grab some extra PVC, as stated above!