IntelliSync Pump Control and Monitoring System

[guinness]

I came across this new product (SKU 523404) from Pentair which I've not seen mentioned in these forums.

Polytec Pools has it listed at $200 on back order and and it looks similar to the Jandy iQPUMP01 offering.

https://www.pentair.com/content/dam/extranet/pentair-pool/residential/manuals/automation/intellisync/intellisync-manual-english.pdf

 

[Dirk]

Huh. Looks to be pumps only. Doesn't mention SWG. Too bad, if that could be used with an SWG somehow, then that would have been a great solution for many pool owners.

 

[mknauss]

Allows control of Superflo VS. That is its primary market I suspect.

 

[guinness]

Tantalizingly they have additional connections for future use; Heater or Solar?

Note: H1/H2 and S1/S2 (Not used - For future use)

At some stage they'll need to replace the Solartouch/Suntouch controllers.

 

[Dirk]

No relay, though. That's what gives an SWG an extra layer of safety. Air and water temp sensors suggest heater control, in addition to freeze protection. Though for solar you'd need to be able to control an actuator, too. My solar uses a third sensor, for the roof temp, so that might be S1/S2. Perhaps H1/H2 for gas fireman switch, or solar actuator? But not both, as an ET can do. That's more than I know about it.