Intelliflo2 pump out, replace with Intelliflo3?

Jump to latest Follow Reply
A

antoniosp

Well-known member
May 14, 2013
164
Austin, TX
My pump has stopped working. There is power to it but it will only work on low speed, when putting on high speed it doesn't work.
I currently have the Pentair 340043 SF N2 1 1/2A HP 230V
I looked online and it seems its discontinued. I found it online at 1 place for about $980
Pentair says replacement is PENTAIR INTELLIFLO3 about $1,300.

Should I purchase same I have or move the Intelliflo3?

Thanks.

​

 
Last edited:
A,

Do you run low speed most of the time? If so, moving to a VS pump will save you a little on your electrical bill, but not a lot, if you never use high speed.

I love large VS pumps as you can run them on low 24/7. This means you can make a little chlorine all the time, and skim all the time. I do this for less than $20 bucks a month.

Thanks,

Jim R.
 
The part number you indicate for your existing pump is a Superflo 2 speed. Not an Intelliflo 2
 
I suspect a Superflo VS would require little to no plumbing modifications. Would need to be sure to get the comm cable to connect to your Easytouch.
 
You must log in or register to reply here.
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Top Bottom
Back
Jump to latest Follow Reply