I don't believe that this is a flow switch issue... The thermistor in the flow switch can make the salt level read low or high compared to the actual salt readings, but it will not make it read zero.
I believe there is a timing issue between the cell and the main board in the EasyTouch. It works in most cases because the two unit's components are close enough, but when one of the units is manufactured with slightly different parts, the problem can pop up. In my case, I have seen the problem a couple of times, and it has gone away when the power was recycled. I suspect that my two units are just close enough to make it work again. This is not the case for most people.
I too see the fix being a software update.. We will see, but until then, my "guess" is a good as any...
Thanks,
Jim R.
I believe there is a timing issue between the cell and the main board in the EasyTouch. It works in most cases because the two unit's components are close enough, but when one of the units is manufactured with slightly different parts, the problem can pop up. In my case, I have seen the problem a couple of times, and it has gone away when the power was recycled. I suspect that my two units are just close enough to make it work again. This is not the case for most people.
I too see the fix being a software update.. We will see, but until then, my "guess" is a good as any...
Thanks,
Jim R.