I have a jandy system and I need to hook in a fire feature to the 24v switch. I'm hoping to use "Aux 4" but I cant seem to get it to actuate on the panel. It says something about RS6 only but the button is there so shouldnt it acknowledge the response when pressed ? Is there a dip switch I need to toggle to make that button work ?
How to get Aux6 working on a Jandy panel ?
- Thread starter johntdyer
- Start date
- Jul 21, 2013
- 53,198
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
Welcome to TFP.
I am going to assume you have an Aqualink RS4 system.
With an RS4 system you have the filter/pump relay and three AUX relays that give you the 4. AUX1, AUX2, & AUX3.
The RS6 system has the filter/pump relay and give AUX relays - AUX1 to 5.
www.troublefreepool.com
I am going to assume you have an Aqualink RS4 system.
With an RS4 system you have the filter/pump relay and three AUX relays that give you the 4. AUX1, AUX2, & AUX3.
The RS6 system has the filter/pump relay and give AUX relays - AUX1 to 5.
Jandy Aqualink RS - Further Reading
www.troublefreepool.com