I have now had over 20 hours of very clear water and my FC is slowly beginning to drop from where I began. I accidentally added a higher than recommended amount of chlorine (25 ppm) to begin, so I am now just beginning to approach (21 ppm) my SLAM target of 20. I had lowered my pH to 7.4 prior to starting, but now it is at 8.0 again. Should I add more MA to lower my pH again, or is it safe to wait out the chlorine drop? Other than starting out with too high a dose of FC, everything is going without incident. Thanks!
High pH As SLAM Is Nearing Completion
- Thread starter ghall6292
- Start date
- Jul 21, 2013
- 52,508
- Pool Size
- 35000
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-60
The pH test is invalid when the FC is above 10. Ignore your pH until your FC gets below 10.
Thanks, Allen. I was pretty sure that was the case, but as this is my first SLAM, I wasn't willing to proceed without reaching out for TFP confirmation here.
Similar threads
