I have an entirely different thread I started August of 2018 regarding a blinking "cell" light on my IC40. So, I've been there done that. In then end, with the help of some fantastic folks here at TFP, we decided that my cell was dead and that I should replace it with an IC60 to better suit the size of my pool and buy a cu later copper remover. Well, here we are again, almost 1 1/2 years later. So, I bought a new IC60 and a cu later copper remover, August of 2018, as suggested. Installed everything and it's all worked very well, up until now. The 1 1/2 year old IC60 is starting to have the blinking "cell" light again. It's springtime, so I know the temperature has been too low for the generator to operate, but the water temp is now in the high 60's so it should be working. Here's what I've done:
1. Checked the chlorine level. It's been low so I've added chlorine to get it to the correct level.
2. pH is balanced
3. Backwashed the DE filter, twice in the past 2 months
4. Acid washed the IC60
I tell you, I'm beginning to think the Pentair products are not right for me. Any suggestions are appreciated. It's pretty early in the morning, so I haven't called Pentair yet. Thank you all in advance. I know I'll get some great advice.
1. Checked the chlorine level. It's been low so I've added chlorine to get it to the correct level.
2. pH is balanced
3. Backwashed the DE filter, twice in the past 2 months
4. Acid washed the IC60
I tell you, I'm beginning to think the Pentair products are not right for me. Any suggestions are appreciated. It's pretty early in the morning, so I haven't called Pentair yet. Thank you all in advance. I know I'll get some great advice.