- May 3, 2014
- 62,729
- Pool Size
- 6000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
Then you can take off the pump basket lid with the other pump on. Once a pool pump is turned off, there is no trapped pressure.
FL Pool Neglected for 3 Years
- Thread starter Bacon_ISF
- Start date
SLAM Day 3-4
Test result below.
Today was day 4 of running the pump without filter. When do you all recommend I put the filter back or should I run without it for a few more days?
Water is cloudy with slight greenish tint.
Test result below.
Today was day 4 of running the pump without filter. When do you all recommend I put the filter back or should I run without it for a few more days?
Water is cloudy with slight greenish tint.
- May 3, 2014
- 62,729
- Pool Size
- 6000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
When you have a full or at least half a day put it back on filter. You will need to babysit it and backwash/add de fairly often to start.
Good progression. Stay at it.
Good progression. Stay at it.
Flying Tivo
TFP Guide
- Jan 24, 2017
- 3,100
- Pool Size
- 7500
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
SLAM Day 5-6
Holy cow! I couldn't believe my eyes this morning. I could actually see the bottom of the shallow end. Water literally cleared overnight. Gotta keep SLAMing though until it's sparkling clear!
Check out this spa pump basket. Never cleaned in 3 years!
On the other hand, after I cleaned the basket and put it back in, the spa pump won't turn on.
What could've gone wrong?
Holy cow! I couldn't believe my eyes this morning. I could actually see the bottom of the shallow end. Water literally cleared overnight. Gotta keep SLAMing though until it's sparkling clear!
Check out this spa pump basket. Never cleaned in 3 years!
On the other hand, after I cleaned the basket and put it back in, the spa pump won't turn on.
What could've gone wrong?
- May 3, 2014
- 62,729
- Pool Size
- 6000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
Did it run before?On the other hand, after I cleaned the basket and put it back in, the spa pump won't turn on.
- May 3, 2014
- 62,729
- Pool Size
- 6000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
Well. Go through the systems and see that everything is set for it to run. No clicks, hums, etc?
Nothing. No clicks/hums. I had to hit the lid open with a rubber mallet. Possibly something's loose inside...
- May 3, 2014
- 62,729
- Pool Size
- 6000
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- Pentair Intellichlor IC-40
Might be. Do you have a multimeter? If you feel comfortable with it, test for voltage at the pump.
Hello guys I'm back again. Water became completely clear last week so I thought I was done with SLAM. There was no overnight FC loss so I let the FC drop to 5 this past Monday.
However there's some fine dust on the bottom that swooshes away when I brush. I've been running the pump two days straight and it won't go away. I noticed FC dropped to 0.5 today so I think there's algae in there again and chlorine is fighting it?
My question is how high should I bring up the FC? Back to 12 or somewhere less?
Almost done I promise!
However there's some fine dust on the bottom that swooshes away when I brush. I've been running the pump two days straight and it won't go away. I noticed FC dropped to 0.5 today so I think there's algae in there again and chlorine is fighting it?
My question is how high should I bring up the FC? Back to 12 or somewhere less?
Almost done I promise!