Hello, I have recently installed a new SWG. The model is a crystal pure 7704 60k. I don’t believe I’m getting the full output. Cell setting at T15 is correct. When the unit is on (it shows a voltage of 21.5 and an amperage of 5.45-5.65.
It is working(I can see the bubbles on the return) but it’s nowhere near what it should be. Am I right when I say these numbers are low? Also, when the unit is not generating the voltage is only 28.6. I have 232 volt going to the swg.
5.6 fc
0.0 cc
TA 90
Ph 7.2
Cya 70-80
It is working(I can see the bubbles on the return) but it’s nowhere near what it should be. Am I right when I say these numbers are low? Also, when the unit is not generating the voltage is only 28.6. I have 232 volt going to the swg.
5.6 fc
0.0 cc
TA 90
Ph 7.2
Cya 70-80