I just changed an aqualogic to prologic. Everything works great except for my lights.
I have the colorlogic 2.5 lights.
What happens is when I turn the lights on I get a nice blue light and in about 5 seconds the light goes off. And it does not turn on again right away. Maybe after some time it does turn on, but only for a few seconds.
when I say turn on I mean with bright light. I can tell it’s getting power but the lights aren’t bright at all. Nothing is tripping, and I can hear the relay clicking when I turn the lights on.
I can barely see some red/blue/white led on but it’s so low I can hardly tell it’s even on.
So the lights seem to be ok and worked fine before changing the main board to a prologic.
Am I missing something? Did I need to change something to get the colorlogic 2.5 lights to work with the prologic board?
Are there some settings I may be missing?
Do I require a different module or something?
I really don’t want to spend the money on new lights and redo all the wiring for them. That would be horrible.
I have the colorlogic 2.5 lights.
What happens is when I turn the lights on I get a nice blue light and in about 5 seconds the light goes off. And it does not turn on again right away. Maybe after some time it does turn on, but only for a few seconds.
when I say turn on I mean with bright light. I can tell it’s getting power but the lights aren’t bright at all. Nothing is tripping, and I can hear the relay clicking when I turn the lights on.
I can barely see some red/blue/white led on but it’s so low I can hardly tell it’s even on.
So the lights seem to be ok and worked fine before changing the main board to a prologic.
Am I missing something? Did I need to change something to get the colorlogic 2.5 lights to work with the prologic board?
Are there some settings I may be missing?
Do I require a different module or something?
I really don’t want to spend the money on new lights and redo all the wiring for them. That would be horrible.