Best way to get Easytouch program to heat at specific time?

[Raytrey]

Howdy! I have an Easytouch panel without the app so the interface is challenging. I have a Pentair Mastertemp Heater hooked up to the control panel.

Right now, I have a daily schedule where the pool pump runs 10 hours over night without the pump.

I have a new situation where I need the pool to be 77 degrees by 9am on M-F. This is only 2 degrees warmer than current temp without any heat.

How should I adjust my schedules to get the heater to engage for just a few hours before 9am? I don’t want heater to run all night.

Is it possible to have one pool schedule with Heater On, and one pool schedule with Heater Off?

Thanks!

 

[Jimrahbe]

Ray,

It is, but I am not sure how to do it using the little LCD... Here is an example where I used ScreenLogic on my PC to change temps based on a schedule..

Schedules1.JPG

• Jimrahbe
• May 27, 2019

ScreenLogic Heaters set up

In "theory" anything you can do via ScreenLogic you should be able to do via the LCD, but I tried and was not successful. That said, I did not spend a lot of time playing with it..

Thanks,

Jim R.

 

[Raytrey]

Ray,

It is, but I am not sure how to do it using the little LCD... Here is an example where I used ScreenLogic on my PC to change temps based on a schedule..

Schedules1.JPG

• Jimrahbe
• May 27, 2019

ScreenLogic Heaters set up

In "theory" anything you can do via ScreenLogic you should be able to do via the LCD, but I tried and was not successful. That said, I did not spend a lot of time playing with it..

Thanks,

Jim R.

Thanks! Yeah I can’t find a way to associate the heater or a temp with a given schedule. I wonder if this is a benefit of having screenlogic :/