Hey all, Been a long time since I posted here, love the community, helped me so much many years ago.
Have an Autopilot with a RC-52 ( PC-4 I think now ). Bought it 8 years ago and installed.
Yesterday I get a message saying Check Cell, before yesterday, Volts and Amps were perfect.
Running on Power Level 1 forever.
I took the cell off, and plates look clean and fine, but did a muriatic acid cleanse just in case.
Salt is at 3600ppm water temp approx 78-79.
When powering off unit, and back on after checking fuses and spider-webs out. I get 30V and 1 amp.
Then turn off again and on, 0V and .6amp. (only saw this one time )
Left the unit off last night, and today when testing with Boost, I am at 24V and 5A.
Lower the power, and Amps go to 4.6 or so.
Not sure if having an issue with the control system or the cell possibly flaking out at times. Any ideas on how to test further?
Left it today on Boost24 to see what happens.
Have an Autopilot with a RC-52 ( PC-4 I think now ). Bought it 8 years ago and installed.
Yesterday I get a message saying Check Cell, before yesterday, Volts and Amps were perfect.
Running on Power Level 1 forever.
I took the cell off, and plates look clean and fine, but did a muriatic acid cleanse just in case.
Salt is at 3600ppm water temp approx 78-79.
When powering off unit, and back on after checking fuses and spider-webs out. I get 30V and 1 amp.
Then turn off again and on, 0V and .6amp. (only saw this one time )
Left the unit off last night, and today when testing with Boost, I am at 24V and 5A.
Lower the power, and Amps go to 4.6 or so.
Not sure if having an issue with the control system or the cell possibly flaking out at times. Any ideas on how to test further?
Left it today on Boost24 to see what happens.