Hi! I have a intex pool and we have the intex vacuum. If you arent familiar with how the vacuum connects it is propelled off of the water as it is circulated through the pump and comes back out into the pool. We have found that it is getting very difficult to remove the cover that stays on the output in the wall and now is almost impossible without a large set of pliers. Does anyone have any suggestion on how to remove this piece without having to break out the tools every time? IT seems as it gets sand in it, as we have a sand filter. Thanks!
Vacuum Problems...
- Thread starter sdavis4606
- Start date
I can't help you with that problem, but I built this valve so that I can leave the vacuum hooked 24x7 and switch back and forth, or run both at the same time.
Sent from my SAMSUNG-SM-J320A using Tapatalk
Sent from my SAMSUNG-SM-J320A using Tapatalk
- Jun 22, 2014
- 47,872
- Pool Size
- 17888
- Surface
- Fiberglass
- Chlorine
- Salt Water Generator
- SWG Type
- CircuPool RJ-45 Plus
Jeff gets my "PVC Creativity Award for the day" 
sdavis, as for your tight output cover fitting, perhaps applying some pool lube? Maybe that will help.
sdavis, as for your tight output cover fitting, perhaps applying some pool lube? Maybe that will help.
