Search results

I instaslled a Circupool RJ45+ about a month or so ago. I am having issues with it making chlorine. It's installed correctly - per the manual, but for some reason it is not making chlorine. My pool is about 11,000 gallons (meaning the R45 should be putting out tons of chlorine for a pool this...

So I received my Circupool SWG and test kit on Monday. I was floored that my ppm was 7000! I used liquid chlorine for a long time now. Off to the rental store, got a pump, and had to drain nearly 50% of my pool (in phases - drain / fill / drain / fill - to ensure I didn't damage the gunite)...

Yet another pool owner that plans on switching from LC to SWG! So reading here I am looking to take advantage of the deals that Discountsaltpool has and buy an RJ-60+. My current setup is as follows: In ground ~12,000 gallon pool In central FL west of Orlando Have a Pentair Intelliflo pump...

Hi all - I have a Pentair Intelliflow pump, and the controller went bad, so I had to replace it. I installed a new controller, but all of my settings that I had setup were now gone. The pump is installed with a Pentair Solartouch controller. I can get the pump to run a regular schedule no...

I have a Solar Touch controller, and an Intelliflo pump. When the Solar Touch turns on the heat, it goes into Solar Hold mode, for about 5 min, then turns on the valve. I am not sure I understand the purpose of this feature, as my pump ramps up to speed quickly enough where I would just like...

I just installed a Pentair intelliflo variable speed pump. I have the Pentair Solartouch solar controller connected to it, as well as a flowvis flow meter. I'm trying to set the recommended flow rate for the Fafco Sunsaver panels that I have installed (2 story house). From what I've read, the...

I ordered a new Pentair variable speed pump from http://www.poolsupply4less.com/. It arrived today, with a cracked base. They are resolving that issue. The other issue I am wondering is - the pump basket arrived wet - it had water in it. When I confronted them about it, they said that they...

I'm looking to replace my current Jandy FloPro 2 speed 1.5 HP with a Pentair Intellipro. Reading the installation manual for the Intellipro, the manual has a warning box that states" The Maximum Flow rate setting should be set so the system never operates at or above 25” of Hg vacuum." Should...

I have been looking at replacing the dual speed pump with a VS pump since we just got solar installed. I am wondering - between the various brands out there, from what I am seeing here, lots of folks seem to recommend the Pentair Intelliflo VS. Is this THE pump to get? The pool we have is...

I've been reading on the board here that most 2 speed pumps cannot prime solar panels, but that it may be possible if the pump ran on high, then switched to low? I have an installer scheduled to come out and install 7 FAFCO Sunsaver panels. I have a 2 story house. My pump is a 1.5 HP Jandy...

We have a 322 sq ft, 11,400 gallon screened pool. I'm looking to add a solar system to extend the season. I think 5 or 6 panels may be what I need based on what I saw at the Florida Solar Energy Center website. There appears to be many different brands of panels that exist - I think we've...