Search results

No I took the daughter board back out. As when I put it in, I lost control of my relays. I am sure I didn’t install correctly. I took it back out and put everything back the way it was, but I am missing something clearly. There is still flow through my aqua rite, but not through my pump. I had...

I have flow to my salt cell. It’s the flow sensor to my pump that is not working.

I don’t know. I tried to install a daughter board, and re wired to connect that. My guess is I did not re install the system back correctly when I removed it. I cleared the system out of my hub and tried to re program, but missed something is my guess.

Hey all- I have been having problems with my hayward system picking up the flow sensor. I have this error on my app. I bypassed the flow sensor otherwise my pump kept shutting off. How can I “re install” the flow sensor and get it connected? Back story- I had tried to install a mother board for...

I installed a daughter board today, and since then, I have lost my relay connections, and now my water flow sensor. Help!! I have done the configuration so many times, and I cannot see where I am missing adding the water flow sensor. Any advice on what section the water flow sensor is in...

Hi- yea it is. That explains that! Thanks!!

Good Morning everyone- over the past couple days I have had air bubbles coming out of my jets- one in my spa and one in my pool. I don’t have any visible leaks, I cleaned my filters last week and double checked. My levels aren’t horrible, I am working on the TA. I added acid to drop ph and then...

It’s the pipe inside the hayward swim clear cartridge system at bottom of system, it is the pipe that sends water out of filter.

Hi all- cleaning out my filter and noticed this small hole in the pipe. Is this normal? Hayward system

The screen shot of my results were of a taylor test kit. I haven’t added any salt. I just turned my salt cell back on. In 5 days it has gone up massively and I am not sure why, hence me asking for advise.

I used the Taylor kit, that was one of my pictures from my post.

Hey all- my salt keeps rising in my pool. Now it’s at almost 4600. Salt cell was turned back on to help with chlorine levels since it was below 0. Now my salt cell is reading high salt. I wasn’t shown how to drain my pool, can someone help me out so I can drain and then add water in? The spout I...

I just turned it back on to 50%, I had it turned off since my salt level was so high. I run my pump from 8a-7pm.

Got it! I think I updated it. thanks "neighbor"!

Hi! I am showing I have my signature filled out! Did I do something wrong?

The water is crystal clear. No issues. I added 92oz of acid to drip my TA as well and now am aerating right get back up. I also added 36oz of chlorine.

Hi All- I am having problems balancing my levels. This was tested using a Taylor Kit. It’s a 10k salt water pool. I added acid and chlorine to pool based off pool math. At a loss on salt levels growing since cell has been turned off for 5 days. Any advise welcomed!! Thanks all.