Search results

Just trying to clear up my recently opened pool. Can someone provide guidance? FC - 41 CC - .5 AK - 70 CYA - 20 Salt - 2350 The pool is blue but very cloudy. Any suggestions on next steps to clear up?

I was looking into replacing an old sand filter and was considering a cartridge filter. The only issue is my equipment is setup under my deck and the space is limited. Does anyone have suggestions for getting a cartridge filter in a max height of 60 inches where I could still open up and pull...

I opened my pool today and got everything started. After pulling the cover off the pool the water level was high (just about top of skimmers). After about 45 minutes of the pool running I noticed the water level was about 1.5/2 inches lower. Then I noticed a portion of my lawn which is a low...

Relatively new pool owner here just looking for help on a few general items. First, I have an intermatic dial timer. The timer works just fine but when I put on the trippers the dial stops where the trippers are but doesn't turn on/off. It doesnt trip the on/off switch but simply stops the...

I keep getting debris build up on the bottom of the pool. Here is the scenario - Pool is clean then I run the pump. After a few hours I'll start noticing some debris on the bottom. I'll clean the pool with my robot and/or my manual vac then by the next day more debris on the bottom. Here are...

Just purchased the TF100 testing kit and I am testing my pool for the first time. Based on some very bad information from the pool store my stuff is all out of order. Here is the result of my first testing: FC - 30 PH- 7.5 CYA - 50 TA - 100 ( not sure if this is correct as the solution is...

I am new to the forum and was hoping to get help with a vacuuming question. I am vacuuming to waste due to use of floc (I know from reading everything here that is not recommended but either way I have already done it). My system is setup with two skimmers and vacuum port. When vacuuming I...