Search results

The tech at the pool store I go to insists I don’t use lube on O rings - says debris attaches to it and not necessary. Thoughts?

Local Walmart has 10% for 5.67 a gallon, 24074. Pinch a Penny has 2.5 gallon refills for ~17.50 - fresh.

IQpump not working, but able to power the pump by jumping it. Narrowed down the problem to the iqpump - it’s either not connecting, has s bad line, or needs to be replaced. Hopefully figure it out tomorrow. Thx again!

Jumping the pump worked, thank you!

Awesome, thx!

I have a Jandy VSPHP220DV2A. So connect 1/3 and 2/4 from picture then reapply power and this should start it? Thank you!

Yes, the pump worked before I powered it off and made repairs. The pump turns off and on with the iqpump and the controls with the outdated panel. There’s power at the panel and at the pump. The iqpump has two settings - quick clean and scheduled. Even if I put my pump on quick clean or turn it...

Replaced my skimmer (2), main drain, and spa valves/pvc - now jandy vsp pump won’t turn on. Attached are pics of pump & panel wiring. Getting 251v @ panel & pump. Any ideas why it won’t turn on? Using outdated jandy panel with iqpump01. Jandy pda lets me switch from pool to spa mode, so I think...

I just opened my filter because water was leaking - probably have a dirty/bad o-ring. Decided to clean out the grids since I have it open. I had a lot of cellulose fiber sludge on the bottom and some stank and looked like algae/mold. Never seen this before. Anything special I need to do before I...

I replaced a Jandy actuator with a different model replacement part. I used the Jandy screws, which were too long, and cracked the 3 way diverter case under the actuator. Now the pump won't prime, I assume it's sucking in air. Can I seal the crack with jb weld or something, or do I have to...

Thank you all - I wired it in to the line side of the relay and now it's working. It looks like the spa drain is pulling water faster than it fills - can somebody tell me which valves to adjust? The labeling wore off. Thx.

Thx for the feedback and sorry for the late response - I've been ooc since Saturday. In the pic below, the wires connected to the first and 3rd screws are 246v and go to the main power switches near my pool. The wires connected to the 2nd and 4th screws are going to the pump - they are not...

No sign of life from the iqpump. The pump is still wired to the aqualink box, the pump light in the box does turn on.

Just replaced my old jandy stealth single speed pump with the jandy vsshp220dv2a. Did not buy the iq20 upgrade kit so my electronics are incompatible, but am trying to use the iqpump01 to run the pump. Can't get the iqpump01 or pump to turn on. All I did was connect the 3 electrical wires to the...

Stuck on step 5. Know where to find that?

Thank you! Do I cut the gas too?

Where do I drain the heater?

Thanks. Here is my setup. I believe the 3 valves on the left are drains (2 for the pool and 1 for the skimmer). Do I open these to drop the water below the skimmer? Then, do I close them to keep water out? What other valves would I close? Then I take off the drain plug from the filter and 2...