Search results

Ok. Thanks.

Thanks. I went to a home depot and they don't have it and neither does the pool supply place. I called Hayward and they said they will get back to me in a week. I called the company that manufactures it, which is on the old wire and they only sell it by 1,000 feet. They said to try an...

I ordered a new gas temp unit (pictured). It comes with the orange wire shown, which is good because mine is rusted. I would like to order some more of that wire because it connects other components in the heater and I'd like to replace any old wiring. Is this sole on Amazon, along with the...

I replaced the filter cartridge and the water coming out of the jet is much stronger now, but I still get lo code and I did unplug the wires and plugged them back in.

Are you referring to the pipes that go into and come out of the heater? I’ve done that already. Or are you referring to one of the electrical components?

It reads zero when off. How do you reset the connector? Thank you!

I'm not in front of it to check to see if it goes to zero when off. When it's on, it's around 15. I don't think it has a bypass - I'd have to disconnect it and re-route it, but I should install a bypass. Also, it's a Sta-Rite pool filter, not a Pentair. Here are some pics

I didn’t make any adjustments to the switch. I just screwed it in, out of the box. The filter and heater and on the ground about 4 feet below the water level.

Sorry. Above ground. Pentair cartridge filter.

Sorry. I have a hayward 150fdn heater and the pump is a hayward power-flo-lx

Yes, I did.

Ok. Thanks. The pressure is the same as it usually is. Is there some kind of pump mechanism in the heater that would cause this?

Thanks. I checked the lines and impeller and no debris. The pump is like 5 years old. It was working fine for a month, could it be that the pump needs to be replaced? It’s spinning but maybe it’s slower?

Hello, I was getting a Lo code on my heater and replaced a few parts and it went right away, it started up and then went right off, a few times and I received an IF code. I replace the igniter then I got the LO code back. The pool does seem like its not pumping as hard, but the pump seems to...

Thanks. I'll try the switch then get the temperature limit switches if need be.

Thanks. I looked online and the switch was the most common issue. I bought the heater on amazon and replaced the heating unit this year from Leslie's. I called Leslies and you get overseas people answering the phone who can't help. They said to call Hayward about a warranty and I can't get...

Hello, I have a H150FDN pool heater. It's worked all summer so far, but last week I noticed that it would turn on for a few minutes then turn off and show Lo. The filter is clean and the output is strong. I ordered a new pressure switch, but in the meantime I took the two wires that connect...

I just got a new heater an ordered a new intermatic timer. I figured I'd replace the 15+ year old wiring going to the heater and pump, but don't know what to get. I already purchased (separately) the flexible conduit, but would like to know what kind of wires I need to connect to a Hayward...

Ok, thanks!

Thanks - looking forward to helping people, where I can. Yes, I have an intermatic timer. I'm replacing an old heater that had the fireman's switch connected, but don't know where to connect it to on the new one.

I just got the Hayward H150FDN heater. I have a timer that was connected to the old heater and to the pump/filter. The connection to the heater is a red, black and green wire combo. There's a fireman's switch with 2 black wires, connected to a brown wire (2 pieces), which was going to the old...