Search results

Planning to start AA stain removal today, but I just realized I don't have any Jack's Purple Stuff on hand. I ordered a few bottles, but they won't be delivered for 2 days. After calling around, it doesn't look like any local shops have any on hand....only BioGuard Pool Magnet plus. My FC is...

My 1.5 HP Superflo VS is finally on it's last leg. I'd like to replace it with a truly VS pump that will work with my EasyTouch controller. Any recommendations? Bonus if the fittings are in the same place as my current pump and no plumbing revisions are needed! Replacing: M48AA95A03

Got back from vacation a few days ago. New salt cell and EasyTouch installed a few weeks ago. Finally tested the water this morning and shockingly (no pun intended) my FC is over 75 (I stopped adding the reagent). I'm in the process of starting a partial drain. Any other advice? I'm kind of...

I think my IC-15 is finally officially DOA after 7 years. I will be replacing it with a larger capacity unit that is more appropriately sized for my pool. However, the power supply with the IC15 won't power any of the larger units, so I am considering an ET panel that is is packaged with an...

Trying to narrow down run time/speed to adequately circulate while at the same time maintaining a high enough flow rate for the SWCG to produce enough to keep my levels around where it should be. First, I realize that an IC15 is not ideally sized for my pool, but it still works after replacing...

I need help figuring out how wire my SWG and VS pump. When I originally switched over to salt several years ago, I still had a single speed pump, and everything was wired together so that the timer controlled power for both the pump and the SWCG. When I upgraded to the VS pump, I took the tabs...

Trying to figure out what combination of equipment would be best and at the same time without spending a small fortune on it. I was all set a few weeks ago to spend some cash doing this, but emergency water heater install derailed that plan and some of the cash flow. Currently, I have an IC15...

My SWCG is on it's last leg...5-6 years old. I think the flow switch is bad...cell still reading 60%, but I'm planning on replacing the whole thing. I replaced my single speed pump with a variable speed a few years back, but still have my sand filter and am thinking about changing over to...