Search results

I have an older SunTouch Controller. The back of the board says Rev. A & the firmware is 1.0. I just purchased a new IntelliFlo VS pump, however when the SunTouch turns on the pump it always seems to be at a high speed. Since the pump's display is disabled, I don't know what RMPs it's running...

OK, I've installed a new Pentair IntelliFlo VS pump & a new Pentair Quad DE filter along with new piping on the pad. The pump primes just fine in around 15-20 sec. and I can see water rushing in from the suction line. After it primes there's a small quarter sized bubble in the top of the lid...

I just installed a new Quad DE 60 filter (this is my first DE filter). I slowly added the 12 scopes of DE per the manual, but my presser gauge only went up to 2-3 psi. Does it take awhile for the DE to coat the cartridges? Or is mt gauge bad? Or did I not add enough DE? This is the scope I used...

I'm installing a new Pentair IntelliFlo variable speed pump (011018) with a new Pentair IntelliChlor IC40. I already have a Pentair SunTouch control system for automation I'm connecting to. The pump is connected to a dedicated circuit breaker on my electrical panel & has the low voltage...

Hi everyone, I'm new here. :-) We bought our house around 6 years ago & the pool & it's equipment are probably around 15-20 years old now. Everything is leaking & failing. I'm planning on doing an equipment pad overhaul & just wanted to get a double check on the layout I've sketched out. I...