Pool Light - went dead
- Thread starter embeleco
- Start date
What brand light is that? If it is an LED, there is not likely a bulb replacement for it. Most that size need to be completely replaced.
I don't know the brand of it. I guess I need to pull it out to find out. It is LED but unsure on the brand.
Since the rest of your equipment is Jandy, likely the light is as well, possibly a Treo or one of their discontinued models. They are not repairable, only replaceable.
- Dec 13, 2020
- 793
- Pool Size
- 19600
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Jandy Aquapure 1400
Looks more-or-less like this. Here is the corresponding manual. If $500 for a light gets your heart going, you're not alone.
Hi. Yes those are the ones I have (I have 3 total) I had some time today to look into it and play with the lights and I think it may be something else.. though not sure. Before I call a service company I want to run it by you guys/gals.
When going through the different light colors using the iAqualink I saw some weird behavior. For example if I selected Cobalt Blue.. my two lights on the Pool are set to the right color but my Spa pool light does not.. it is set to a lighter blue (but all three are on). Also for example if I selected Alpine White.. the Spa light changes to White.. the light on the sun shelf turns white as well.. but the other light on the pool.. even though is on and with a white color is not bright enough to lit up the pool area where it is installed (when Cobalt blue or any other color is selected it is bright enough).
Now if I selected Sky Blue for example.. the sun shelf light stays off while the other 2 are ON. I didn't went through all the colors.. but I can't have problems with all 3 lights... so what is in common? Finally selecting Caribbean Blue.. the sun shelf light starts changing colors on its own while the other two are static on the selected Caribbean blue.
I will run through all the colors tomorrow night and see what other behaviors I found.. but wanted to post here in case someone had the same issue. I'm afraid that all my 3 Lights are bad.
Thanks.
-Jose
Last edited:
- Dec 13, 2020
- 793
- Pool Size
- 19600
- Surface
- Plaster
- Chlorine
- Salt Water Generator
- SWG Type
- Jandy Aquapure 1400
I have zero experience with these lights, but I'd definitely try the sync procedure and then the troubleshooting chart in the manual. For example the chart says low voltage due e.g. to bad connections can cause color sync problems. That's an easy one to rule out if you can get the lights onto the pool deck and use a meter.I'm afraid that all my 3 Lights are bad.
