All done :-)

Enjoying this content?

Support TFP with a donation.

Give Support
Automation is finally fixed. Here is what they did;
  1. Replaced the protocol adapter
  2. Replaced the short range antenna with a long range antenna
  3. Replaced the protocol adapter again
  4. Replaced two personality boards (One in each panel)
  5. Replaced the protocol adapter for a third time (phone can now communicate to panel but panel can’t communicate to pumps)
  6. Replaced two mother boards and two personality boards and the discovered an improperly wire communication link between box one and box two, killing all coms from the boards to the pumps.
See if you can see the problem;
7781B87A-FF65-42ED-B490-B34091A5F147.jpeg
 
Automation is finally fixed. Here is what they did;
  1. Replaced the protocol adapter
  2. Replaced the short range antenna with a long range antenna
  3. Replaced the protocol adapter again
  4. Replaced two personality boards (One in each panel)
  5. Replaced the protocol adapter for a third time (phone can now communicate to panel but panel can’t communicate to pumps)
  6. Replaced two mother boards and two personality boards and the discovered an improperly wire communication link between box one and box two, killing all coms from the boards to the pumps.
See if you can see the problem;
View attachment 388684
Positive-Negative switched at the top
 
  • Like
Reactions: BigPapaSmurf

Enjoying this content?

Support TFP with a donation.

Give Support
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.