How close should liner seams match to contours?

Jump to latest Follow Reply
J

jamjam

Well-known member
Jun 25, 2020
684
NY
Pool Size
25000
Surface
Vinyl
Chlorine
Salt Water Generator
My liner seems pretty snug - but I noticed in the shallow end, the seam, where the wall meets the floor, is offset a few inches in on the floor. So about 2 inches of wall liner is on the floor, and there is about a half inch gap in the corner behind the liner where the wall and floor meet. Any reason for concern? Is this within expected tolerance
66CAFA7C-6058-4E84-BCC1-FDD7C55EC609.jpeg

08B34B47-1813-40C5-8C52-043B9311DA26.jpeg
5B1918CA-8F51-4F28-9D52-AB76EFF688A9.jpeg
 
I’m looking at the pre-fill picture and I can see the coving. According to this site some degree of coving is acceptable Pool Liner Coving - not sure what to think

0800B758-5449-4353-ABD8-4F59428ADD84.jpeg
It looks like it also could be from the padding. Hmm...
D3EB85B4-6A92-4CF7-85AA-5C98AB584C34.jpeg
 
Last edited:
You must log in or register to reply here.
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Top Bottom
Back
Jump to latest Follow Reply