Recent content by texasfin

Thanks for reply. Bought it new February 2022. Impeller spins freely with my hand. Cleaned off one or two strands of hair on the impeller. Dan

My Maytronics S200 runs for a few seconds then stops (video). Yesterday I took everything apart, deep cleaned. Removed every last tiny leaf in the tracks. Ran for a full session and thought I had it fixed. Then stopped again today. During the out-of-water test today it again seems like the...

Alright thank you so much. Will ask inyo about V Green VS

I’m replacing the motor on my 1 HP Hayward Super 2 pump. Pump Model SP3007x10AZ. (The label on the motor itself is burnt to a crisp impossible to read). Shopping online at Inyo pools I want to make sure I buy the right voltage to match what I’m taking out Below is the bad motor electrical. 1)...

New motor from what I can tell is <$200. It’s this one I think: Hayward Super II 1 HP SP3007X10AZ Replacement Motor Kit AO Smith UST1102 w/ GO-KIT-2 Then it would be a matter of installing it myself which I wouldn’t need special tools for, correct?

Ok ok. So I’d be buying this: Hayward Super II 1 HP SP3007X10AZ Replacement Motor Kit AO Smith UST1102 w/ GO-KIT-2 …and either figuring out how to install it myself or have someone install it for me. Right?

Thanks for speedy help. 10 years sounds about right I knew the previous owner who talked about his pool sometimes. I would post a pic of the motor data plate, but if it’s the one on top of the motor housing facing up (which I assume it is) it’s burnt to a crisp. Hardly can make anything out...

Thanks for fast replies. Are bearings something I could do? Recommended tutorials or should I just YouTube it? Although I have never worked with motors before if it’s simple and clear enough I can learn. I like to start off easy, inexpensive fixes and move up. Or save time/money and jump right...

Sorry. Here is is… 21111401053362017

Here’s a video of my failing pump (Google Drive file) Today I replaced the capacitor on the back of the pump (where the wires are). The above video was made after that. Does this type have two capacitors? If so I don’t know where the other is. I can turn the shaft easily from the back of...