Recent content by stuyyyy3

Thanks. Do you use any other products like sequestrants, algaecides etc.? Or am I good with just acid, bleach and CYA when needed?

A couple of random questions : 1. If you ever needed to shock the pool, wouldn't CC go above 0.5? So you should never really need to shock unless that happens? 2. Does it matter if there is some calcium scaling on the bottom of the pool (which was there before the refill)? It's hard to see...

Yes I put the return to the spa and the suction from the pool. Thank you for the tip. How long should I use the pump for the pool? It's a VS pump but I've seen some people running them for as little as a few hours a day. Is there a guide on this somewhere?

Ok I have some updated measurements and questions : pH : 7.2 (added acid to lower TA yesterday) TA : 120ppm CH : 225-250ppm CYA : <30 (probably around 20 or 25, 10g is still dissolving in a sock in the skimmer which should take it to 30). FC : 4.25ppm 1. By using the spa return jets to make...

Thanks, 3ppm of bleach (for final volume of 23000 gallons) would be 3/4 of a bottle? So just put that in now? The pool is a few hours into filling and it'll take a couple of days i'd say.

The pool is now refilling. When should I add bleach and CYA etc? Should I wait for it to be totally full first?

OK thanks. So should I aim for a target TA of 80ppm? Should I do this by reducing pH to 7.0? Will it then slowly rise to the 7.5 pH level I'm after?

OK. Why did you need to lower TA after your refill? Isn't 160ppm or so a good level to begin with? Would you recmmend me getting it to 80ppm as well? Should I do this after I get the other levels stable first? Thanks The SWCG sounds good, I'll have to look into it eventually. Is it possible to...

Ok thanks. I'm planning on getting the pool to the following measurements FC : 4ppm pH : 7.5 TA : 160ppm (as is) CH : 250ppm (as is) CYA : 30ppm Questions 1. Do those amounts sound about right? It really only needs a jug of bleach and around half a jug of muriatic acid for a 22500 gallon...

Thank for the tip. My pressure washer has a pretty low pressure nozzle attachment. So I'll try that. Mainly just wanting to use it on the tile as the plaster looks fine.

Tested the source water this morning (Summerlin, Las Vegas). Taylor K-2006C Test Kit FC : 0.6ppm pH : 8.0 (kit only goes to 8.0, might have been 8.2?) TA : 160 ppm CH : 250 ppm Thanks for teaching me about Calcium and it's relation to CH :)

Thank you

See this report - 2017 for big bend. They came up with 77ppm calcium. Big Bend 2017 Water Quality Summary I'll test the water tomorrow from the faucet and see what I get.

Haha it must suck to work on. I can choose to use that or the side returns on the pool. I vacuum by hand currently :(( lol Thanks, that worked. Pool is currently draining. I read that Vegas water has 70ppm Calcium in it. So if my pool has 70ppm after the refill. Do I need to raise CH to...

Hi all. Inherited a pool that I'm emptying and refilling due to high CYA and calcium levels. The pool overall is in good condition and doesn't need any sort of acid etching that will reduce the life of the plaster. I plan on jumping in there with my pressure washer to remove dirt etc. and a...