Recent content by pool508

Sorry for the late reply! Thank you for the comments

Hi all! I am looking to setup the screen logic or if I can the intellicenter. I would like to be able to control my system from my phone , what is everyone’s thoughts? Here is my setup: 16x32 Black Granite Full Width Vinyl Over Stepsl (7ft Deep), Pentair Intelliflo VST 2, IC40, Master...

Whats a decent/good pool cleaner for 550 and under? i saw the aquabot junior and it seemed pretty good. Any suggestions?

Jim, I am a newbie, i need to learn all this fc/cya stuff. its going to take me time

Jim, I am running my swcg at 40%, im trying to keep just enough chlorine and have more the salt feel, I will normally set it higher if i have a party. This is my first pool and i am trying to understand it. I do like the idea of not priming and just have it run a lower rpms everday, unless i...

So I have been running 2k RPM for 12 hours a day, and I was thinking of changing it to 24/7 running at 1500rpm, any need or specific reasons why I should? I know there are 2 factors that may need to run at a specific flow which is my heater and IC40. What I have setup seems to meet the needs for...

I have a 16x32 running with a ic40, I have the swg set to 60% is that to high ? I felt like it was a bit to much Chrloine , if I want less and more salt feel , do I just turn it down ?

Correct Jim, My system didnt turn on at 7am this morning, just because i turned it back on at 730pm yesterday, so i just turned it back on this morning at 730am, like you mentioned it will go back to its normal schedule when it cycles its 12 hour period. Still trying to learn and use this darn...

So I have my Easy Touch, pump, heater set for 7-7, once it goes off and I turn the pump back on to run for a few hours then turn it off, will it automatically go back to its schedule?

I have the pentair vst 2, I was wondering what is the lowest RPM I can keep it at to run 24/7? my pool is 16x32, looking to be energy efficient and also keep my pool clean. I think manuelly here and there, i will ramp it up for a few hours.

Finally opened my pool today and just got the chance to turn my light on, doesn’t seem as bright I would like or thought my pool is 16x32 with a black granite liner, could it be the liner that make it no my appear as bright? Also, when I change the lights on my easy touch doesn’t seem to go I...

Jim, I was thinking of having 3 auto modes 1-Running 24/7 at low rpms, setting heater to 80degreegs. I want the pump to only ramp up when heater is turned on)also make sure heater isnt runnign when im sleeping), leave SCWG at 5 2-Have another auto setting for Parties(in the event there is a...

Thanks Jim, I was thinking running it 24/7 at low rpms, just wasn’t sure what people did. There is to many variables when to run and when to have off

Here is my equipment 16x32 - 7ft deep end Pentair intelliflo 2 VST Pentair Master Temp 400 Intellichlor Pentair intelli bright LED Pentair Cartridge Filer EasyTouch so I been reading and everyone has diffent schedule on when to leave their pump running and etc. I’m finding it’s all over the...

Hello Everyone, I just joined the forum, so i finally plugged the trigger and got a pool, I am hoping to get some info and learn more about my system. Specs: 16x32 - 7ft deep end Pentair intelliflo 2 VST Pentair Master Temp 400 Intellichlor Pentair intelli bright LED Pentair Cartridge Filer...