Recent content by Pool$

Thank you for the validation. The reason why I raised the autofill was it is noisy due to the spout being just outside the water. Going to have to try to find the sweet spot where autofill and skimmer are happy.

I recently adjusted my auto fill level raising the water level above the top of the skimmer weir. Around the same time, surface skimming essentially stopped. Is this an expected result? The top of the weir is under water, so surface debris aren't sucked into skimmer?

There is flow - I have verified. I've tried turning flow up very high and still get the error. Resetting the breakers and restarting the system clears the error and the SWG operates normally for a week or so. System is a about 14mo old. Reported issue when it was about 12mo old. edit: I...

The SWG has been throwing a low flow error lately and when I called Pentair they told me acid cleaning is necessary every few months.

Is there a part number for a cap for my Intellichlor SWG so I can perform the muriatic acid maintenance soak?

This fixed it! The pool had the wrong light type and the spa was blank. Thank you!

The iAqualink app is no longer giving the option to change the color on our spa LED's. The pool and spa lights are controlled separately on the app and we used to get a popup asking what color you wanted when you toggled the lights on and off. Then a couple weeks ago, the popup stopped and you...

I bought a Warrior SE this summer and love using it except for the cord. After one session, the cord ends up twisted so bad the robot cannot reach all of the pool. It has a swivel on the cord near the robot, but it doesn't seem to work well.

Does this sound right? I've seen older posts saying folks have a minimum of 1000-1200 rpm for their SWG, but I've dropped mine down to 600rpm and it shows Flow and Cell On. I'm wanting to run longer at lower rpm to save energy, and don't have very much skimming need. AquaPure PLC1400 Jandy VS...

Is it ok to leave our umbrella in the cabo shelf hole for a weekend? Could it leach anything into the pool? Would not be for stretches longer than that. Just thinking for convenience if we plan on being in the backyard all weekend?

I'm asking because it would be nice to throw in something to keep pH down in a salt pool while out of town and not rely on Trichlor.

No, I tried adding it after in Service mode. That would explain it. Thank you!

I found this other thread that has a potential solution by pressing a reset button in the control panel. I'm not going to do it right now, because the builder has the system in Service mode to balance the new pool chemistry.

Setting up iAqualink 2.0 on new pool. I have it connected to my router and the lights on the housing indicate wifi and internet connection. I created an account, but when I try to "add location" I get "enter valid serial number" error. I'm using the 12 digit code that is on the housing and on...

great info, thank you!!