Recent content by ngooo

this is great, i think the stainless steel and kevlar guard should help a lot. Will have to check local prices. Thanks again.

thank you so much for the tip. my pool is rectangular 14x32, I will have to measure the actual cable lengths. Not sure on diameter, will have to measure it. No idea on tensile requirement. Up in Canada, there is a foot of snow on it. The issue is the nylon rubs against the stone, and the...

Hi All, The cable has been rubbing against the stone and with the recent snowfall, the cable is broken. I am looking to find a cable replacement but all I see online is the red cable which doesn't look as solid as this grey cable. Does anyone know what kind of cable this is, that I should be...

Hi All, I have a valve that is used for pumping water out of the pool. it is in the off position but still allowing water out. do i need to replace a gasket or the valve?

Inspired by this thread, picked up toilet seat hinge from home depot to make work.

Hi All, I have two Hayward GVA24 actuator valves that controls the pool and spa modes. On the display/board, Valve 3 and Valve 4 is available, but when i press it, nothing happens. The valves work fine, and when i move the switchs manually, they work, but pressing the valve 3 button doesn't...

Hi, I have a Hayward aquapod 2.0, i have the pump filter running from 8am to midnight, is there a setting to have the heater only run between 8am to 7pm?

the water level is not a problem, just me wanting to make it better. If you look at post #38, the water is sitting just above the jets in the corner. During spa operation, If just 1 or 2 sit in there, and don't splash, the water is okay. If kids jump in and out and take the water with them...

yes, very similar setup, with the spa jets running, the actuator closes off the pool circulation. Jim, I am not comfortable removing the coping or stones to play around with the height of that valve. The wife would kill me if i ruin the look by adding things on the stone. Thoughts on...