Recent content by ncrealestateguy

Thanks. When you say check it, do you mean to pull it out and submerge it in hot water to see if it moves or what? I have the polymer headers.

My heater will cut off and give me a High Limit 1 error code and then after a few minutes will kick back on. Gas pressure is fine at 11.2 inches of water, (it is a propane heater), I put in new burners and pilot, and cleaned the heat exchanger fins. Water flow going into the heater is fine...

Thanks for your reply. I wish I would have seen it earlier, as I did order the Waterway rotating nozzle as referenced by InyoRob a few posts up. I only ordered one, as I suspected that what you pointed out was the case. I will try it out and update here soon.

So, in your first picture, the top piece should be able to just unscrew from my plumbing? And, if I get these new ones, do I just leave the stock 3/4" nozzle out, or put it back in? Also, any other options, besides the rotating one that you show? It would be nice to have three different options...

Here is what I have... the black outer ring is 2 & 5/16" wide and screws into the plumbing coming out of the gunite. The white, 3/4" nozzle screws into the air line or the flex pipe, back up into the cavity. I can not tell from the online pics, if any of those are direct replacements. I...

I will look for part numbers when I pull one out. I am assuming they are the same as most of the gunite hot tubs being made out there.

Yes, the outer ring screws off and then the guts pull out. Once these are removed there is about a 9/16" nozzle about 3 or 4 inches inside that can be wrenched out. I will take one out and take a picture after work tonight. Pool and hot tub was built by A&S.

First, is there such a product? My hot tub was built with the ordinary nozzles that only emits large boring bubbles. Are there message jets, or roto jets or pulsating jets that are a direct replacement of my stock nozzles. I found this link, but have no idea of these will be a direct fit...

I have an IC - 40 and mine did the same thing. I repaced the Flow Meter and solved the problem. You can find them on Amazon.