Recent content by Mcecere11

Water is balanced well and clean. I did add some sand to the filter last year after I cleaned it out. Could it be that since I did that it needs more pressure?

I have Pentair VS pump set at 1800 Rpm’s and have had this as the default for the last 7 years. This year it seems like the first jet is pressurized and working fine but the other 4 are not pushing water unless I increase the speed at the pump 3-400 rpm’s. What could be causing the issue?

Hi guys have a pentagram intelliflow vs that was whining the other day and I didn’t get a chance to look at it and of course today I went out a found an error that said overload. Last year I replaced the electronic module. Did the motor seize maybe seize? Replace the whole pump or is it easy to...

You can see some areas are wet. Likely after some rain. I usually will power wash it prior to sealing it and use some simple green. Use a peer blower to get everything off. This pic I was taking of dog lol so I can post a better pic later.

Have a stamped concrete deck that is about 8 years old. Some parts seem to be fading a bit. I wanted to restain it but I’m not sure what product to use. I’m usually a diy’er so thinking I could tackle it. Any suggestions on approach or product to use ?

Yes the tracks move freely of upside down.

nothing happens. I tested my power supply with his robot and the test runs fine. I also tested my cord by using a multi meter and unscrewing it at the motor connection and got 27V. Is the only possible scenario that the motor is bad? Does nautilus sell just the robot?

I just used my neighbors power supply to test it with my cleaner and it didn’t work. Is it worth replacing the motor? Any reason why it seized? Don’t see anything lodged in it or any other issues.

Wondering if my motor somehow seized or if its something else I can't figure out. I tried testing it with multi meter and disconnected the cord from the motor and was receiving ~28V which is what I read is expected. Didn't smell like anything was shorted. anything else to check? its about 5...

yes got low salt reading with new flow switch so i bought a new cell since i assumed that wasnt the fix and didnt see anything else on the forum. Installed the new cell and working fine. salt reading 3400 using my test kit

isnt the thermistor on the flow switch though? i replaced the flow switch assuming that it was bad

Dang...guess ill be repairing it as a backup. thanks for the advice!