Recent content by Marty D

The seam is ok. Loop lock covers the seam with that 1 inch cloth. It was glue on from the factory.

I just put in alga 60 in and ran a small pump into pool water hope not to have green water again like last year because that was one tuff job to get rid off. Thanks for the tip.

I did called them. They want me to remove all the spring before bringing it in. That 10 year warranty does not cover that pice that came off. I also told them there is 5 little holes in cover. That is also not covered under the 10 year warranty as she said those holes are from squirrels. heck...

The mesh loop lock cover the 1 inch that covers the seam came off on the side facing the pool water. The 1 inch seem to be a cloth that’s glued to the cover. As in the picture but that’s the up side of cover. What is the best glue to use ? The cloth that came off is 1 inch x 35 ft.

I check for any codes. None. I don’t think it’s smart to run heat pump at night ? Look at the numbers . Heat pump runs all day 7 am to 7 pm and water temperature gets to 83 84 degrees. Shut down for the night and at 7 am water temperature is 79. Run it again in day time by 12 it’s 82 degrees by...

I had the heat pump on for 3 days and two nights. I normally don’t run heat pump at night but kids are here for the weekend and I wanted 84 degrees water. I had 84 degrees yesterday. I keep the heater on Saturday night and when I got up at 4 am the heater was off and said defrost mode. I checked...

Thank you. Marty D

Tr Ok. That’s what he must of been doing. How do u adjust it and do I have to worry about any seals -0rings that may leak.

Yesterday the guys are redoing all the pavers around my pool. After they left I now notice the skimmer cover snaps on in a different position. I don’t care but how did he turn the skimmer housing? Do I have to worry about leaks ? Looking at picture the two little screws are my alignment they...

Yes- I know. Getting a new liner in September if he does it. Was to be done in April but with this virus everything is on hold. Still didn’t pick out a color or the thickness 22 or 28 mil.

0.1 copper in my pool after I added it this morning

I tested for copper.1