Recent content by jasong

Look into the foam lift option. They inject badically spray foam to lift the slab and fill the gaps. I have had both done in commercial applications and the foam seems to work better.

I would have to have two bad check valves since I have the flowvis on the outlet of the pump and befor the filter and a jandy check valve after the filter. skimmer----->pump------>flowvis------>filter----->check valve--------three way solar valve----->SWCG------------->Pool The solar leaves...

Re:  Losing prime over night ANyone have any other ideas?

The jets were very low cost here too. I really wanted laminar but for 800 they put in the 4 jets with the 3way automatic valve. Hit the button on the phone, pump ramps up and jets start. Its a cool ow cost novelty

I have 4 of them on our pool with a three way valve on the return that either diverts the water to the stairs or to the deck jets. Wife hates the noise but the 3 year old loves them. I enjoy them since the neighbor dogs bark non stop. They drown out the dogs :)

Re: Losing prime over night Thats correct. I have isolation valves after the pentair solar 3 way and on the return back from the solar. Every night the past 2 weeks i go out at about 8pm after the pump has shut down and im sure the solar has drained down and close the isolation valves and...

Re: Losing prime over night Thats what im trying to get my head around. How is an air leak on the solar side getting past two check valves? Technically the solar system is always going to have an air leak since during drain down it fills with air via the vacuum breaker

Hope someone can point me in the right direction cause this is driving me crazy. A few weeks ago i started loosing prime overnight when the pump is off. I have isolated the problem to the solar system by shutting down the service valves going to the roof at night. I dont understand how this is...

Can you rebuild it? Going to get blasted pretty good with water but a 5 minute rebuild shouldnt drain the pool. Matt the drain to reduce flow bedt you can and rebuild

Yes 31

Been a long day..anyway ran the OCLT yesterday / thismorning and had a loss of 1. Spent an hour brushing / vacuuming and the floor feels great. Seems were on the way.

I brush at every use and if were not using it, at leadt evry 3 days. 2 walks around the pool, sides first then slopes followed by bottom. Typically turn off skimmer and run all floor drain while doing this

Not showing any green. When i get in and stir it up, slippery goes away.

FC is up there. Had to order some spare test solutions from TF since im going to be using a bunch this week! Added 10% and brushed twice. Time to sit and wait. Will vacuum tonight when i get back

Heading to walmart