Recent content by goldmaes

  1. G

    IC40 and Easytouch

    My salt cell recently went bad and I replaced the cell with an identical IC40. Everything now lights up appropriately and my easytouch sees the system and appropriately turns it on when the pump comes on. Since the pool builder set up everything originally I never looked at the easytouch...
  2. G

    Heating Time Calculator

    This is my fear. While it hasn’t been that windy I do believe your theory is possible. You Are correct, there really isn’t a way to do a cover on the pool. Additionally, I don’t think a chemical cover would work as the water is constantly flowing over the perimeter edge.
  3. G

    Heating Time Calculator

    Thanks. Any clue then on why it doesn’t meet the calculations? Is there a variable I am missing?
  4. G

    Heating Time Calculator

    Thanks, the problem with these and above is they all calculate that with 135000 BTUs that moving the temp of my water from 68 to 85 in my 12000 gallon pool should take between 11-20 hours. I am at 36 hours and I am 2 degrees away from that. What I cannot tell is what I need to do to get the...
  5. G

    Heating Time Calculator

    Does anyone have a heat pump calculator that if I for instance put in the ambient temperature, starting water temp, desired temp, pump flow rate, how long it should take to heat up a pool of x gallons with a heat pump of x BTU? My heat pump has always been slow and there is no good calculator...
  6. G

    Post Rennovation

    Thanks so much! After years of fighting with the pool builder, it seems to be finally complete!
  7. G

    Post Rennovation

    Sorry for the delay, let’s hope this time the tiles stay attached to the pool!!!!!
  8. IMG_4985.jpeg

    IMG_4985.jpeg

  9. IMG_4987.jpeg

    IMG_4987.jpeg

  10. G

    Pentair Overcurrent Issue

    Thanks, I will!
  11. G

    Pentair Overcurrent Issue

    It appears that the motor has seized. The pump is only approximately 4-5 years old. Thoughts on replacing the motor vs the entire pump?
  12. G

    Pentair Overcurrent Issue

    No signs of a leak, motor appears to be seized. Even the fan won’t turn.
  13. G

    Pentair Overcurrent Issue

    I am taking everything apart but when I reach in I cannot move the impeller nor do I feel an obstruction.
  14. G

    Pentair Overcurrent Issue

    While I did not take the cover off the fan I did try to stick a screwdriver in and manually tried to manipulate the fan and it didn’t budge. I would be surprised if it really is seized as it is only about 4-5 years old. My gut is that it is stuck due to being off for 9 months during the...