Recent content by Eyetattoo

Replaced the flow switch and all is good again, thanks for the help.

Cleaned and checked the unit this morning, the switch is still there but now thinking the sensor is bad. Ordered a new one that will be here tomorrow so fingers crossed that will fix the issue.

Returns are flowing and this video was taken after the cleaning cycle was going for roughly 30 mins. Normally they flash like that for 5 mins or so.

Here are screen shots from the video. The top two lights flash back and forth between the two. The third light is staying solid red.

Lol dam autocorrect, fixed now.

Went out this morning to backflush the sand filter and noticed the salt cell showing no flow and flashing lights. Any ideas of what might be going on? Thanks! https://youtube.com/shorts/fJtjRSGKeA4?feature=share

What's your target FC with a SWG?

Water is crystal clear so maybe I'll try the oclt test first. I have some liquid CYA on its way so hopefully that will fix the issue.

Water looks good but I am loosing too much chlorine every day that my IC-60 can barely keep a FC reading of 1.0. Last Wednesday I raised the FC to 5 with liquid chlorine and this morning it was back to 1. My pump runs at 1,700 rpms for 8hrs/day and 3,100 rpms for 3 hours per day. Here are my...

I must have something in the water as I loose way too much FC. The water looks good but there is too much loss. I,m going to SLAM and then hopefully my SWG will be able to keep up with daily demands.

I have a SWG so that is my concern. I seem to be having to run my SWG more than I expected. I run the circulation for 8 hours at 1,700 rpm and I run the cleaning cycle for 3 hours at 3,100 rpm. My test readings show FC at 1.0. I know my CYA is too low so I'm bringing that up to 70. Hopefully...

Trying to figure out the gpm for my pump. In the manual there is a chart but I can't figure out how to properly read it. I run my pump at 1,700 rpm for circulation, 3,100 rpm for the cleaner and 2,300 for our spa spillway. Here is the chart for reference. Thanks for any help!

That's what I normally do, you are right it takes too long to jump the FC quickly using the SWG. Thanks!